x
Cart

BMW EWS2 Immo Emulator

Product Code : EBM0023
Brand : Bmw
16.50 EUR
16.50 EUR
Features
  1. BMW EWS2 Immo Emulator
  2.  
  3. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted.
  4. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR
 
 
 
  1.  CONFIGURATION UTILITY:
  2.  
  3. EWS2 SOFTWARE
  4.  
  5. Choose COM port, write in desired ISN number, press button Store. Or -
  6. For some ECU s it is possible to read ISN number directly from engine control unit. In this case select option "ECU xxxxx", press Read. Software will try to read ISN. If successful, choose option "EWS emulator" and press button Store to save ISN number into emulator.
  7. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to DME(DDE) <-> EWS line.
  8. Don't forget to short two starter relay wires (EWS connector)!
  9. Car is ready to start.

 

 

In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to diagnostic K-line.

There are NO any counters or car starts limited. You can change and store new ISN without any limitations.

Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.

 

Support & parameters:

support all  BMW EWS2 EWS3.2 IMMO (immobilizer) (E34, E36, E38, E39, E46).

Can not be used on CAS immo

Make sure your car is EWS2 and EWS3.2 IMMO


FIG.

BMW EWS3
 

 
 

 

 

Prepared by  T-Soft E-Commerce.